#Homeseer hs3 software#
This software plugin is installed by default on all HomeTroller systems. HS3 or HS3PRO Software or HomeTroller system.100% Locally Processed Commands for Maximum Performance, Reliability and Security.
#Homeseer hs3 manual#
Allows for Manual Command Route Settings.Supports Network Rediscovery ("Healing") for Individual Devices or Entire Networks.Works with Multiple Z-NET IP Interfaces for Centralized Management of Large Residences, Outbuildings, Condos, Apartment Complexes or Commercial Properties.Supports Multiple Z-Wave Networks for Unlimited System Scaling Any HomeSeer system running HS3 software v3.0.0.500 or higher.Includes Over The Air (OTA) Firmware Update Feature.Works with Z-Tool+ Mobile App for Easy Network Setup.Supports a Wide Variety of Z-Wave Devices Including Wall Dimmers and Switches, Thermostats, Door Locks, Sensors, Garage Door Controllers, Water Valves, Sirens, Door Bells, Handheld Remotes, Plugin Modules and more.Integrates HomeSeer HS3 Systems with Z-Wave Interfaces from HomeSeer, and Aeotec.This software plugin is designed to allow HomeSeer systems to control Z-Wave devices of all brands and all types. However, the setup/config pages are not optimized for use on mobile devices. After almost 2 years of running HS3, now HS4, and HA in parallel, I’ve decided to shutdown my HA instance and move the little I have running in HA back to HS4.
From Version 1.093b onwards, MQTT Config can now be done in the Config tab of the plug-ins web page. HS4 users: This plugin was created for HS3 and should run on your HS4 system. This post was made at the start of the COVID lockdown here in NorCal and at a time when the future of HS4 was in question. If so then your MQTT Broker and your TasMQTT.ini configuration are correct otherwise go back and check the MQTT broker is running, the configuration is correct both on the Broker and the TasMQTT.ini is in the Config directory under Homeseer HS3.
0 kommentar(er)
